How to align the floor with a cement of screed or lag First you need to check how even your floors are. All potholes and inclinations should be excluded.

To level the floor, use the cement screed or installed lags.

Then you need to lay out the floor with a moisture -resistant plywood, it should be 2 centimeters thick, this will make the design more reliable. With the help of dowels, you need to glue the plywood, and use screws to attach it to the lags. If necessary, plywood should be polished.

And now you can proceed directly to laying parquet. Parquet strips must be glued to the finished plywood. If necessary, the bar can be nailed using nails. Everything will dry for almost a week, it all depends on the quality of the glue you have chosen. After the parquet dries it, you need to grind it.

This will help to remove all the irregularities, clean from the dirt that could form in the process. The formation of irregularities is possible after the glue dries, and dirt can form when laying. The remaining gaps should be cursed.

When the putty dries, you need to grind again.

And now you can proceed to the last stage – varnishing. The quality of varnishing will affect how long your parquet coating will last. First you need to process the floor with a stain to achieve the required shade.

First, apply a layer of primer, it will not allow the varnish to absorb inside the parquet bar.

Start varnishing only when the primer completely dries.