Technological process and stages of plastering slopes
Sometimes it happens that after installing the door or window, slopes become spoiled. In some cases, you can simply smear cracks, but it also happens that the plaster falls completely. You can only fix this with plastering sloping. First you need to prepare a solution of cement and sand. The solution must be plastered deep cracks. While the solution is hardened, prepare the lighthouse on which the slope will be equal. A lighthouse can be a simple wooden rail, which is attached to the edge of the slope. After that, you can proceed to the process of plastering slopes, which consists of three stages.
The first stage is called spray. It is necessary to apply a layer of solution to the surface, 3-5 mm thick. Having done this, you will create a reliable base for the following layers, because the solution will fill all small cracks and holes. A thicker solution cannot get into them.
Then you need to pose a primer of the slopes. The thickness of this layer should be from 15 to 20 cm. After applying the soil to the surface, it must be leveled with a half -terrible and lighthouse. Alignment must be tied to. It should turn out that at the base of the slope, that is, near the window, the layer will be thicker than at the edge.
After applying the soil, you will have a almost ready -made slope. But you need to apply another layer, the third. This layer is called covered, its thickness varies from 2 to 4 cm. Then you need to let the slope dry out, and after that you have to wipe it.