Light steel thin -leaf structures for the construction of a monolithic wall
During the construction using technology using light steel thin-leaf structures, the process of manufacturing the walls is as follows:- the frame of the carrier panel of thermal profile, based on LSTK, is filled with the mats of the mineral insulation;- the end is covered with a wind-deck membrane;- the panels of the ventilated facade are carried out;- inside;- inside;- inside;- inside;- inside; The steam-barrier (special film) is strengthened;- a gypsum cardboard, glass-fruits sheet or any other wall material is finished.
This technology has variability, expressed in various factory readiness of the elements of the building and materials used for external and interior decoration. Only LSTK, insulation and finishing materials can be delivered to the construction site, and finished wall sections with partially or fully installed finishes can act, depending on its type.
According to the requirements of the customer for the timing of construction and its value, with greater factory readiness, the deadlines are significantly reduced, but the costs of transportation and use of lifting equipment are increased. With full assembly on the construction site, respectively, the temporary indicator increases, but the cost decreases due to the refusal of specialized equipment, an increased amount of transport and a decrease in damage to the natural landscape.